- 9 -
5.7.
Connect the Anchor grouser
# 25 (150mm)
with Anchor post
# 24 (250mm)
using self-tapping
screws
# 45
so that you get
T-shaped Anchor-legs.
5.8.
Insert the
Anchor-legs
into the side post from
below until it stops, fix with two self-tapping screws
# 45.
5.9.
Install the all Anchor-legs in all other racks in
the same way.
Attention!
For mounting Anchor-legs
Into the end posts, you must first
unscrew the self-tapping screws
connecting the post and the
lower crossbar, mount the leg,
and screw the self-tapping
screws back.
6. INSTALLATION OF CELLULAR POLYCARBONATE (CP) TO THE ENDS
Important!
For Polycarbonate positioning it is important that all cellular lines be located in a
vertical position (downwards). Be sure to remove the wrapping film from both sides of
the sheet. The manufacturer marks the work face (sunward) of cellular polycarbonate
with a certain mark (a color bar, sticker or other).
To prevent moisture from entering the polycarbonate open honeycomb and inside
the greenhouse, we recommend sealing the joint of polycarbonate sheets along the
entire length with a waterproof self-adhesive tape (dense tape or similar material).
