- 10 -
6.1.
Cut a sheet of CP with a size of
6000x2100mm
into parts according to the
diagram.
6.2.
Attach
part “B”
to the end door, aligning the bottom edge of the CP with the
bottom lintel of the end. Fix the CP with self-tapping screws #
46
(19mm)
through
thermal washers
#47
according to the scheme for attaching polycarbonate to the
ends (Ext.).
Layout of polycarbonate sheets at the Front/Back Ends
6.3.
Attach
part “A”
to the left side of the end and
part “C”
to the right side of
the end, aligning the lower edge of the CP with the lower lintel of the end. Fasten
parts “A” and “C”
with self-tapping screws
#46
(19mm) through thermal washers
#47
according to the scheme for attaching polycarbonate to the ends (Ext.).
6.4.
Fasten
part “D”
above the door according to the scheme for attaching
polycarbonate to the ends (Ext.).
6.5.
Mount the polycarbonate on the second end the same way.
6.6.
Cut off the extra edges of the CP along the outer edge of the frame.
6.7.
Cut a horizontal gap between the doors in parts
“B”.
