- 12 -
7. INSTALLATION OF CELLULAR POLYCARBONATE (CP) ON SIDE WALLS
Cut a sheet (if necessary) of CP with a size of 6000x2100mm into parts according to
the scheme
For wall mounting, Use parts
“E”
with dimensions of 1050x1600mm are used.
7.1
. Start installation of CP sheets from the ends. Attach the Polycarbonate sheet
to the wall of the frame. The upper edge of the sheet should be 1 cm below the
junction of the rafter and the rack. The side edge should be aligned with the end post
(no protrusion).
7.1.
Start installation of CP sheets from the ends. Attach the CP sheet to the wall
of the frame. The upper edge of the sheet should be 1 cm below the junction of the
rafter and the rack
. The side edge should be aligned with the post (no protrusion).
7.2.
Secure the CP with #
46
self-tapping screws through #
47
thermal washers to
the intermediate arch post, 3 self-tapping screws per post according to the diagram:
Attention! The CP sheets are not attached to the end posts!
(The vertical polycarbonate will be fixed with an outer corner on both ends.)
