- 13 -
7.3.
In the same way, overlap the remaining side panels of the CP with the previous
ones. Mount the sheets on the opposite wall.
7.4.
Bend the outer part of the
#
31
drip angle slightly along its entire length so
that the corner can be put on the top of
the CP sheet.
7.5.
Place the
#31
drop corners on top
of the Polycarbonate sheets along the
entire length, tight to each other.
8. INSTALLATION OF CELLULAR POLYCARBONATE (CP) ON THE ROOF
For installation on the roof,
Use parts “F”
with a size of 1050x1400mm are used.
For ease of installation, we recommend carefully laying the frame on its side.
8.1
. Start installation of CP sheets from the ends. Lay the polycarbonate sheet on
the roof slope, aligning the top of the Polycarbonate along the ridge, the side edge of
the Polycarbonate along the end rafter.
Fix the Polycarbonate with #
46
(19mm) self-tapping screws through #
47
thermal
washers to the rafter, 3 screws per rafter according to the diagram.
The Polycarbonate sheets are not attached to the roof ridge down the middle!
Fit the remaining roof sheets with an overlap with the previous ones.
