44
(figure 37) Loosen the clamping lever(2) one turn, This will loosen the headrest(3). If desired, now the
headrest can be taken out of the clamps. The fixation nock(4) can be adjusted in height. The fixation
nock ensures that the headrest is positioned at the same height over again when the headrest was
removed from the wheelchair.
To place the headrest, it should be inserted into the headrest clamps. Than the clamping lever should
be tightened hand-tight again.
The headrest consists of loose shackles(5) (figure 38) these can be set in such a way that the headrest
is set in the preferred height and angle above the backrest. The shackles can be set by loosening the
cap nuts (6) and hand tighten them again in the desired position.
Figuur 38: Instellen van hoofdsteun
The headrest in figure 38 is shown with spacers with fixlocks(7). These fixlocks serve to secure belts
or chest vests.
