www.velgehome.com
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
FOR COOKER HOOD MODEL VCCH9002.1 B, 230-240 Vac - 50 Hz
Exhausting cooker hood. The equipment is constructed in accordance with European Standards and with the requirements included in the
following Directives: 2006/95EC ( Low Voltage Directive), 2004/108 (Electromagnetic Compatibility).
INSTALLATION
Read the instruction manual before installing and/or using the hood.
The unit must not be mounted above cookers fitted with top radiant plate.
Respect all the air discharge regulations.
The air must not be discharged in a pipe used to discharge exhaust fumes
produced by gas-fed equipments or fuel-fed equipments (this does not
apply to filtering hoods).
The room must be adequately ventilated when the hoods is used together
with other gas-fed or fuel-fed equipments. For an easy access, it is
advisable to move possible furniture under the installation area.
Installation of the hood onto the wall.
The hood is equipped with all the necessary fastenings for its installation,
which are suitable for most surfaces. Anyway ask a professional to verify
that the installation surface is strong. Installation must be carried out by
qualified installers according to present regulations.
1)Draw and drill the wall as in
Picture 2
2)Fix on the wall the screw anchors with the wall cupboard support
(A)
3)Fix with screw anchors
(C)
the support of the telescopic chimney
(B)
4)Put the screw anchors on the holes
(D)
5)Fix the hood to the wall cupboard support see point 2), two people are
needed for this operation
6)Block the equipment with two screws as in
(E)
, to reach these fastenings
open the glass door and remove metallic filters.
7)Place the telescopic chimney on the upper part of the hood and fix the
support with screws as in
(F)
.
ELECTRICAL CONNECTIONS
This equipment must be connected to a grounding plant. Two types of
electrical connection can be used:
1)Using a standard plug to be connected to the power cable and inserted
in a mains socket which must be accessible (so that the plug can be
disconnected when servicing is carried out). Make sure that the plug is
accessible also after the complete installation of the equipment.
2)By means of a fixed mains connection, fitting a bipolar switch, which
ensures the disconnection, with an opening distance of the contacts
allowing a complete disconnection on the conditions of the overvoltage
III category, according to installation regulations. The ground connection
(yellow-green wire) must not be interrupted.
Refer to the plate inside the hood for the mains voltage and frequency
ratings.
EMPLOYMENT
GB
PRESENTATION
The equipment
(Picture 1 )
is made of the following items :
1)Cooker hood body
2)Telescopic chimney
3) Perimetric glass
Summary of Contents for Kniven
Page 1: ......
Page 25: ...www velgehome com 1 3 A E C 2 F B D ...
Page 26: ...www velgehome com ...
Page 27: ...www velgehome com ...
