www.velgehome.com
speed buttons switch on with a fixed light for 30 seconds to remind that
aluminium anti-grease filter need cleaning.To set the timer to zero keep
the button T4 pressed with the aspirator switched off, otherwise the timer
will remain set on 30 hour functioning and the reminder will occur again
when the hood is switched off again. Charcoal filter (for filtering hoods)
Once the hood is switched off, after 120 hour functioning, all leds blink for
30 seconds to remind that the charcoal filter need cleaning.
To set the timer to zero keep the button T4 pressed with the aspirator
switched off, otherwise the timer will remain set on 120 hour functioning
and the reminder will occur again when the hood is switched off again.
MAINTENANCE
Always disconnect the hood from the mains before carrying out any
maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that
are designed to trap particles of fat contained in the fumes. The metallic
anti-grease filters must be washed at least once a month with detergent in
hot water (or in the dish-washer).
ATTENTION
: the grease collected in the filters can easily catch fire and it
is therefore extremely important to clean the metallic filters on a regular
basis as per instructions.
The activated charcoal filters are designed to collect unpleasant odours in
the cooking fumes. The air is then released purified in the environment.
The charcoal filters must not be washed, but replaced 2 or 3 times a year,
depending on how much the hood is used. New filters are to be requested
directly to the manufacturer. In order to replace the activated charcoal
filters, you should remove the anti-grease filters. Your are then to take off
the activated charcoal filters placed at the two ends of the aspirator. Turn
the filters until they unfasten from aspirator (Picture 4 - G).
Invert the operation in order to install the new charcoal filters.
In order to remove the remaining glue or any impurity, the cooker hood
must be cleaned immediately after installation and after having removed
the protective film.
The cooker hood must be cleaned frequently both internally and externally
This cooker hood can be employed as exhausting or filtering.
Exhausting (external evacuation). Kitchen smokes are driven outside
through a flue joined to the exhaust pipe flue connector. Install this flue as
indicated in picture 3
This pipe must not under any circumstances be connected to cooker,
boiler or burner exhaust pipes, etc.
Filtering (inside recycling). Smokes pass through the activated charcoal
filter (Picture 4 - G) to be cleaned and recycled in the kitchen environment
by means of holes from which the purified air will come out. These holes
have to be free and communicating with the kitchen environment.
OPERATION
The hood is supplied with a multispeed motor.
The hood should be run at low speed under normal conditions and at
higher speeds only when there is a heavy build-up of fumes or odours.
Ideally, the hood should be switched on as soon as cooking is started and
then kept on until all odours have been eliminated.
The controls consist of touch screen commands. Press
TL
to turn on the
light, press
T1
to swich on the hood at first speed and to switch off the
aspirator, press
T2-T3-T4
to select functioning speeds.
Adjustable and delayed self switching off
Choose the desired speed while the hood is working, then keep the speed
button pressed until it starts blinking. This button corresponds to the
desired self switching off minutes. Please keep in mind that:
T1
corresponds to 5 minutes
T2
corresponds to 10 minutes
T3
corresponds to 15 minutes
T4
corresponds to 20 minutes
Filters maintenance reminder
Aluminium anti-grease filters
Once the hood is switched off, after 30 hour functioning, all the leds of the
Summary of Contents for Kniven
Page 1: ......
Page 25: ...www velgehome com 1 3 A E C 2 F B D ...
Page 26: ...www velgehome com ...
Page 27: ...www velgehome com ...
