VELGE Mjosa, Installation, Operating And Maintenance Instructions

www.velgehome.com

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS 

FOR COOKER HOOD MODEL VCCH 9013.1 X, 230-240 Vac - 50 Hz

Exhausting cooker hood. The equipment is constructed in accordance with European Standards and with the requirements included in the 

following Directives: EN60335-1 ( Low Voltage Directive), EN55014-2 (Electromagnetic Compatibility).

This equipment can be used by children aged 8 or more, people with 

physical, mental and sensory disabilities or inexperienced users it they 

were instructed under proper supervision or trained on the safe use of the 

equipment and if they are fully aware of the related risks. Children shall 

not play with the equipment. The cleaning and maintenance are at user’s 

expense and shall not be performed by unsupervised children.

- As soon as the equipment is delivered, remove the package immediately. 

Verify its overall aspect and, should any type of anomaly be found, notify 

it immediately to the sales point or the installer.

- Its equipment is intended for domestic use. 

It shall not be employed for 

industrial or professional purposes

 nor for any other purpose than that 

for which it has been designed.

- The supplier will not provide any warranty for the consequences and 

damages caused by an improper installation or a misuse of the equipment.

- Do not attempt to modify the characteristics of this equipment, that would 

represent a hazard. Repairs shall be exclusively made by a specialized and 

authorized

 technician. To avoid risks, the manipulation of the equipment 

is strictly forbidden so is the replacement of the 

power cable

.

- If the fume hood is not supplied with a power cable and a pin or any other 

means for the disconnection of the mains power supply, with a separation 

of the contact between all poles that provides the total disconnection 

under conditions of overvoltage category III,  shall be incorporated to 

disconnecting means to the fixed system, according to the installation 

rules (two- pole switch directly connected to power supply terminals which 

shall have a separation of the contact between poles so as to interrupt the 

supply of electricity in case of overvoltage category III).

- Once the equipment has been installed, the disconnection of the 

equipment from the power supply shall be allowed. Disconnection can 

be done by keeping the jack accessible or adding a switch to the electric 

system in accordance with the installation rules.

- If the power cord is damaged, it shall be replaced either by the producer, 

its customer service or qualified personnel in order to avoid risks.

- It is of vital importance to place particular attention as to where the wall 

or ceiling will be perforated so as to verify the presence of hidden electrical 

cables, pipes or iron beams, etc. This may cause serious breakdowns, 

electrical derivations or the transmission of noises and vibrations.

- IMPORTANT: During the installation phase, before electrically 

connecting the equipment, always disconnect the power panel that 

will supply it (differential or thermal-magnetic of the general house 

switchboard).

- WARNINGS: Always disconnect the exhaust hood from the electrical 

outlet before proceeding to cleaning and maintenance operations by 

plugging off the electrical outlet, differential or thermal-magnetic of 

the general home switchboard. To clean the exhaust hood, never use 

steam or high-pressure devices (rules regarding electric safety).

- It is forbidden to cook directly on the flame or operate the gas stoves with 

no container to cook on the same flame (aspirated flames may damage the 

equipment and the warranty will be cancelled accordingly). The use of the 

equipment on a fuel stove is not authorized (wood, coal,…).

- Frying under the equipment shall be constantly monitored since oils and 

fats being subjected to high temperatures may ignite. Do not flame under 

GB