If you record 2 messages, record the fire alarm and panic/emergency
alarm message as message no. 1, the burglar alarm message as
message no. 2.
The procedure to record the message is : press REC, press 1 / 2 / 3 (as
message no. 1, no. 2, no. 3), press REC (you will hear a long beeping
sound and the REC LED will come on then you can start recording),
then press CE (to stop the recording).
Press REC
Press 1 / 2 / 3 (depends on message no. 1, no. 2, no. 3)
Press REC
Press CE
Note : 1. After you press REC, 1 (or 2 or 3) and REC, if you hear 3
beep sound and the REC LED does not light. It means there
are some messages already stored and cannot record again.
You have to clear the memory first.
2. The recording capacity is 20 seconds, when the total
message recorded is over 20 seconds, the REC LED will
come off and recording is stopped.
3. When recording, make sure you are facing the microphone
and the distance should not be more than 30cm.
4) Change the recorded message
If you want to change any portion of the message recorded, you first
have to erase/cancel all the recorded messages, then afterwards
record the new messages all over again.
5) Cancel the recorded message
If you wish to cancel the recorded message, press REC, 0, and REC.
All the messages will be erased in the same time.
Press REC
Press 0
Press REC
