AVMOD16N1 / AVMOD16CCN_v2
- 4 -
VELLEMAN
b.
Auto-scan Mode
If you wish to use several cameras (up to 3 units), you can allow the channels to run in automatic scan mode. Define
a channel for each camera and switch on each channel on the receiver. The scan mode will switch channels each 5
seconds. If you do not wish a camera to be scanned, simply de-activate it by placing the channel switch on the
receiver in to OFF position.
8. Troubleshooting
If you obtain no or a distorted picture, check the following:
•
Are the power adapters for camera(s) and receiver correct (voltage) and properly connected?
•
Is the monitor or TV switched on?
•
Are the appropriate channels selected / switched on or off?
•
Is there a microwave oven or other disturbing device in the signal path? If so, switch it off, move it out of the path
or relocate camera(s) or receiver.
•
Is the distance between the camera and the receiver greater than the transmission range?
•
Is the receiver antenna positioned for optimum reception?
9. Technical Specifications
Camera
Power Supply
7.5VDC, 200mA (included)
Power Consumption
1.3W
Dimensions (on stand)
100 x 95 x 40mm
Operating Temperature
0-50°C ; 32-122°F
Image Sensor
1/3" colour CMOS
Resolution
450 horizontal TV lines
Lens 8mm
Min. Illumination
8 Lux
Receiver
Power Supply
7.5VDC, 600mA (included)
Dimensions
112 x 62 x 18mm
Operating Temperature
0-50°C ; 32-122°F
Total Weight
105g (0.25LB)
Reception Range
up to 90m (300Ft)
Video Output
1Vp-p 75
Ω
Wireless weatherproof colour camera:
AVMOD16CCN
The information in this manual is subject to change without prior notice.
Camera 1
Camera 2
Camera 3
Receiver
