CTC1000RC
V. 01 – 12/06/2013
6
©Velleman nv
signal has been transmitted.
6.
Set up connection between remote control
and control panel
1.
Open the battery cover, for example with a coin,
and remove the battery.
2.
When replacing an old battery, press any button
on the remote control twice to fully discharge the
device.
3.
Insert a new battery (always use the correct
battery type: see Technical specifications). Make
sure the polarity is correct.
4.
On the CTC1000 control panel, go to the Add
Device menu (see chapter Managing devices in
the control panel manual).
5.
Refer to the control panel user manual to
complete the learn-in process.
7.
Using the remote control with a stand alone
siren
When using an outdoor siren as a stand-alone (see
manual for outdoor siren for setup), you can use the
remote controller as a master control. This function
is designed to disable tamper protection before
changing the siren’s batteries.
1.
On the remote control, to start the siren’s
learning mode, press the home arm + panic
buttons.
