DEM600
V. 01 – 20/12/2023
4
©Velleman Group nv
4.
Features
This device can detect stud, metal and unshielded AC live wire. Press
the Mode Switch Button to the desired mode.
•
STUD SCAN MODE
: Three different stud modes for finding wood or
metal studs. Choose the right scan modes can help the accuracy of the
scanning. If you don't know the depth of the detection, it is
recommended to use 1⁄2’’ scan mode first. When the 1⁄2’’ scan mode is
not detected, use 1’’ or 1
1⁄2’’ scan mode instead.
o
Stud 1⁄2 in
ch
. Scan Mode: Detects wood or metal studs up to 1⁄2
in. (13 mm) deep.
o
Stud 1 inch. Scan Mode: Detects wood or metal studs up to 1 in.
(25 mm) deep.
o
Stud 1
1⁄2 in
ch. Scan Mode: Detects wood or metal studs up to 1½
in. (38 mm) deep.
•
METAL SCAN MODE
: Detects metal up to 2.36 in. (60 mm) deep.
•
AC SCAN MODE:
Detects live unshielded AC wires up to 2 inch.
(51mm) deep
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
The Center Marking Point
8
1½ in.Stud Scan mode
2
Stud Mode Indication
9
Power Button
3
Metal Mode Indication
10
Mode Switch Button
4
AC Mode Indication
11
Scan Button
5
AC Wire Warning
12
Battery case (Back)
6
1⁄2 in.Stud Scan mode
13
Stud direction indication
7
1 in.Stud Scan mode
14
Low Battery Indication
6.
Battery
1.
To replace the battery, make sure the device is switched off.
2.
Open the battery compartment at the back.
3.
Take out the old battery and replace with a new and identical 9 V
(6F22) battery following the polarity markings inside the compartment.
4.
Close the battery compartment.
Low Battery Indicator:
When the battery
level is low, the screen will
display a low battery icon, indicating that the battery needs to be replaced.
Warning:
Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.