DVR4H5
V. 01 – 03/06/2014
6
©Velleman nv
8.
Getting Started
1.
Make sure the connected cameras are powered on.
2.
Set the power switch of the DVR at the back of the device to ON.
It takes about 15 to 30 seconds to start up.
Menu Overview
•
Move your mouse to enter the DVR password with the password keypad.
The default user name and password are both “admin”.
The status will change from
(key lock) to
(unlock).
Right-click anywhere on the screen to show the main menu, and right-click again to exit.
QUICK START
Click to set the status display, image settings, and date & time.
SYSTEM
Click to set the system configurations.
EVENT INFORMATION
Click to enter the event search menu.
ADVANCED CONFIG
Click to set CAMERA, DETECTION, ALERT, NETWORK, DISPLAY, RECORD, DEVICES, DCCS,
IVS & NOTIFY.
SCHEDULE SETTINGS
Click to set record timer, detection timer & alarm timer.
Refer to the full user manual on the included CD-ROM for more details.
Setting Date and Time
Before using the DVR, the time and date shall be set to get a valid time stamp.
1.
Right-click the screen and enter the admin password.
2.
Click the QUICK START icon.
3.
Select TIME SETUP to set date and time.
Note:
once recording started, do not change date or time as this will make it very difficult to find back the recorded files.
Note:
when using the DVR for the first time and the correct time is set, leave it on for at least 48 hours.
Password Setting
1.
Right-click the screen and enter the admin password.
2.
Click the SYSTEM icon.
3.
Go to ACCOUNT. Select the password you want to set and click EDIT.
Note:
an operator cannot access the main menu, only the quick menu bar (see below).
4.
Press the cursor up (
) or down (
) button to select the value of the first number and press enter to save and go to
the next character, or use the mouse to select the desired value. Repeat this for all four password numbers.
Note:
the default admin password is
admin
.
Record Settings
1.
Right-click the screen and enter the admin password.
2.
Use the arrow button to select ADVANCED CONFIG.
3.
Use the arrow button to select RECORD.
4.
Select the record type you want to set (manual, event or timer).
