DVR4MQAEB
- 24 -
VELLEMAN
E.
Snapshot
:
Press this button to take a snapshot of the current image which will be saved in the designated destination.
F.
Close the player
.
NOTE:
•
When pausing the playback picture, press “
” button to go to the previous frame or press “
” button
to go to the next frame.
•
In the playback mode of the software AP, press ”
“ button to check the authenticity of the
BACKUP
VIDEO
. If the
BACKUP VIDEO
has been altered, the video image will turn to light red and the playback will be
paused.
NOTE:
•
Remote recording does not support the watermark function.
ADVANCED SETTING
Press the “System Config
” button to enter the system setting page.
NETWORK
The network configuration allows the DVR to connect to
an Ethernet network or dial-up.
1.
Static IP:
Enter the “server IP”, “gateway”, “net mask” and “web
port” and press “APPLY” to confirm.
2.
PPPoE:
Enter the “username” and “password” provided by
your ISP (Internet Sever) supplier and press “APPLY”
to confirm.
3.
DHCP:
This DHCP function needs to be supported by router
or cable modem network with DHCP service. Choose
the DHCP IP type and press “APPLY” to confirm.
NOTE:
PPPoE and DHCP network connection type
will require applying DDNS service to get a
“Hostname” to correspond to dynamic IP address.
See
DDNS
p. 26 for more details.
NOTE:
Some routers may need to restart the DVR to
get the IP address.
4.
Web Port:
The DVR can be viewed over the network with
software AP or a web browser. Typically, the TCP
port used by HTTP is 80. However in some cases it is
better to change this port number for added flexibility or security. Valid number is 80 ~ 19999.
