DVR4MQAEB
- 27 -
VELLEMAN
DEVICE
1.
Select the desired channel of the installed external device.
Press “Edit” to enter the setting box.
2.
Device Type
:
Choose either general camera or PTZ camera.
3.
ID No.
:
Choose the ID number (0 to 255) of the installed external
PTZ devices.
4.
Protocol Type
:
Choose “NORMAL” protocol for our own brand camera.
Choose “P-D” (PELCO-D) protocol for all VELLEMAN
cameras.
5.
Baud Rate
:
Set the baud rate of each channel (2400, 4800, 9600,
19200, 38400, 57600, 115200), depending on the specifications of the dome camera.
6.
Press “OK” and “APPLY” to confirm.
DETECTION
1.
Select the desired channel and press “Edit” to enter the
motion detection sensitivity and area setting box.
2.
Motion Detection Sensitivity:
Set the detection sensitivity in 4 different adjustable
factors.
LS:
The sensitivity of comparing two different images.
The smaller the value, the higher sensitivity for motion
detection.
SS:
The sensitivity towards the size of the triggered
object on the screen (the number of motion detection
grids). The smaller the value, the higher sensitivity for
motion detection.
TS:
The sensitivity towards how long the object gets
triggered. The smaller the value, the higher sensitivity
for motion detection.
RE:
The value of RE is a reference for detection. The
bigger the value, the higher sensitivity for motion
detection.
3.
Alarm:
Select LOW / HIGH for the alarm polarity.
4.
Clicking the area with the mouse and choose the motion
area to be detected. The detection area is a transparent
picture while the undetected area is in pink colour.
*Click the “
Select All
” to clean the previously selected
detection area.
*Click the “
Clear All
” to activate the detection area as
full area.
5.
After setting, press “OK” and press “APPLY” to confirm.
NOTE:
Enable the motion detection function. When the motion is triggered, the “
” icon will appear on the screen.
The software AP will start recording automatically.
