03 #
RECORD-DELETE PINS OR CARDS FOR OUTPUT 1, 2, & 3 (Locations 10, 20 & 30)
Total of 1,200 User PINs and/or Cards are available for the 3 user groups to control the 3 outputs.
1) 1,000 ---- for Output 1 (Group 1)
2) 100 ------ for Output 2 (Group 2)
3) 100 ------ for Output 3 (Group 3)
The Private User PINs and Cards in the 3 user groups MUST be unique. Repeated PINs will be
rejected. Secondary User PINs in the “EM Card + Secondary User PIN” can be repeated. See the
Important Note --- Programming Criteria for Codes in page 14 for more information.
USER GROUP LOCATIONS
– Group 1 --For User PINs/Cards Controlling Output 1
1,000 Users are allowed in group 1 for O/P 1
– Group 2 --For User PINs/Cards Controlling Output 2
100 Users are allowed in group 2 for O/P 2
– Group 3 -- For User PINs/Cards Controlling Output 3
100 Users are allowed in group 3 for O/P 3
SELECTION OF OPERATION MEDIA
Number 1, 2, 3 or 4 represents the Media to be used to operate the keypad.
Number 5 is the authorization code for deleting of an PIN and/or Card from
its User ID.
= EM Card only; = Private User PIN only;
= EM Card + Secondary User PIN = EM Card + Common User PIN
= Delete an User PIN &/or Card from the selected User ID number
= Clear all the PINs & Cards from the selected Location.
It takes few seconds to a minute to complete depending
on the Location selected and the data stored.Please see
the programming example below for the details.
USER ID NUMBER
A 3-digit ID is an identified number for each User PIN and/or Card.
Repeated ID number will be rejected by the system
a) ID Number
000
-
999
for 1,000 User PINs/Cards to operate Output 1
b) ID Number
001
-
100
for 100 User PINs/Cards to operate Output 2
c) ID Number
001
-
100
for 100 User PINs/Cards to operate Output 3
CARD &/OR USER PINS
The User PINs can be 4-8 digits. Key in the User PIN on each ID Number box, then confirm it with #
key
Just simply put the EM card close to the reader window to read it on each ID Number box, then,
confirm it with # key if it is a Card ONLY, or Card + Common User PIN entry. The Common User
PIN is NOT required to key-in here. It will go into its location automatically after the Card is read.
Read the Card first, then key in the Secondary User PIN on each ID Number box, then confirm
it with # key if it is Card + Secondary User PIN. The Secondary User PINs can be duplicated
or a proprietary User PIN but can not be a duplicate of a Prime Code. Owner can use the same
secondary User PIN for a group of Cards as a group Common User Code (or called Department
Code) for a specific relay output.
Cards (Operation Media # 1, 3, & 4) and Private User PINs (Operation Media 2) MUST be unique.
A repeated EM card or Private User PIN will be rejected and one long beep will be generated by
the system to notify the owner.
10
-
30
1
-
5 000
-
999 #
10
20
30
1
2
3
4
5
0999
CARD &/OR USER PIN VALIDATION
LOCATIONS
MEDIA
USER ID
CARD &/OR USER PIN
17
