11
Adjustment & testing
Your K8022 is capable of grabbing and memorising the code transmitted from
the Velleman two channel RF remote control transmitter.
At the factory, the K8022 processor has been pre-programmed for operation
without a custom code (i.e. no jumpers on remote). There is no need to enter
the learn-mode if no code has been set on your remote control. Should you ex-
perience interference due to other Velleman remotes with identical code set-
tings, then you can set a different code on your remote control (see remote
control manual for ‘how-to’ instructions). Once the transmitter code is set, the
K8022 will need to learn and memorise it.
Volume will now turn to zero.
Learning cycle is completed
and the new code will be
memorised. Repeat this proce-
dure if code is not memorised
correctly
(e.g. due to interference). Code
will be retained in case of power
failure.
The unit is now ready for use.
Fasten the lid with the two sup-
plied screws as shown.
Adjustment and testing (continued)
How to operate the learn-mode:
•
Press and hold SW1 (Channel 1) and plug-in power supply.
•
Release SW1
•
LD2 will turn on briefly.
•
Press ‘volume down’ (left button) on remote.
•
LD2 will turn on briefly to confirm.
•
Release ‘volume down’
•
LD1 will turn on briefly
•
Press ‘volume up’ (right button) on remote.
•
LD1 will turn on briefly to confirm.
•
Release ‘volume up’
•
Channel indication (LD3&LD4) will toggle briefly.
•
Press both remote control buttons simultaniously.
•
Channel indication will toggle briefly to confirm.
•
Release both buttons
