LPTA410
1
VELLEMAN
LPTA410 – 4-CHANNEL CHASER -- 16 PATTERNS
1. Introduction
At the end of its life cycle, dispose of this product in accordance with local and national disposal
regulations. Read the manual thoroughly before bringing this device into service
Thank you for buying the
LPTA410
! This device features 4 channels and is equipped with a 16-pattern chaser.
Make sure that the device was not damaged in transit. If the device is damaged, you should contact your dealer and
postpone installation of this device.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
•
A qualified technician should install and service this device.
•
Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for the ensuing defects or problems.
•
Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is essential, therefore, that the device be earthed. Have this device
installed by a qualified technician.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace
the cord if necessary.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
•
Do not look directly into the light source as sensitive people may go into epileptic seizure if they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty. Keep the device
away from children and unauthorised users.
3. General Guidelines
•
This device is a light controller for professional use on stages, in discos, theatres, etc. This device should only be
operated with an alternating current of max. 230Vac/50Hz and is designed for indoor use only.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device will be protected against extreme heat, moisture and dust.
•
Do not use or transport the device under temperatures < 5°C or > 35°C.
•
Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur, will probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
Note that all modifications of the device are forbidden for safety reasons.
•
Do not remove the serial number sticker from the device as doing so will void the warranty. Only use the device
for its intended purpose. All other uses may lead to short-circuits, burns, electroshocks, lamp explosion, crash,
etc. Using the device in an unauthorised way will void the warranty.
