__________________________________________________________________________________________________________________________________________________________
19
OUTPUT
TRANSFORMER
ZD043
TRANSFORMER
8D002
POWER
TRANSFORMER
ZD043
OUTPUT
WIRES
WIRES
WIRES
WIRES
ADHESIVE
FOOT
FOOT
ADHESIVE
FOOT
ADHESIVE
WIRES
ADHESIVE
PROTECTION
FOIL
PROTECTION
FOIL
ADHESIVE
PROTECTION
FOIL
ADHESIVE
FIG 6
◊
Turn over the housing and solder the transformer leads to the output terminals, see figure.
4
0
8
BLUE
YELLOW
RED
HEAT-SHRINK
SLEEVE
FIG 7
Do not forget to insert a 3 cm length of insulating heat shrink sleeve over the wires:
Solder the double yellow wire to the 4 Ohm loudspeaker terminal.
Solder the red wire to the 0 loudspeaker terminal.
Solder the blue wire to the 8 Ohm loudspeaker terminal.
IMPORTANT: Heat the terminals up until the solder melts easily. Then slide the insulating heat
shrink sleeve over the leads.
◊
Twist the previously soldered red and yellow wires together and fit them as shown in the figure, the
cable ties supplied can also be used.
OUTPUT TRANSFORMER
ZD043
YELLOW
RED
BLUE
8
4
0
ZD043
OUTPUT TRANSFORMER
BLUE
RED
YELLOW
8 0 4
FIG 8
