17
Twist the previously soldered red and yellow wires together and fit them as shown in the figure,
the cable ties supplied can also be used.
Mount the supply transformer in the middle of the cabinet. Ensure that the leads are positioned as
shown in the figure 6. The thick grey and green wires must be at the highest point.
Mount an output transformer along the right-hand side of the housing, see figure 6. Check the
position of the wires.
Solder the transformer leads to the output terminals, see figure 7. Do not forget to slide a 3 cm
length of insulating heat shrink sleeve over the wires:
Solder the double yellow wire to the 4 Ohm loudspeaker terminal.
Solder the red wire to the 0 loudspeaker terminal.
Solder the blue wire to the 8 Ohm loudspeaker terminal.
IMPORTANT:
Heat the terminals until the solder melts easily.
Then slide the insulating heat shrink sleeve over the leads.
OUTPUT TRANSFORMER
ZD043
YELLOW
RED
BLUE
8
4
0
ZD043
OUTPUT TRANSFORMER
BLUE
RED
YELLOW
8 0 4
Fig. 8.0
IMPORTANT: Ensure that the transformers do not touch any metal parts
such as the loudspeaker terminals or the input connector.
!
Assembly into the unit
