16
q
Position the main PCB in the aluminum profile that is prepared with the feet.
q
Mark the center position
of the three fixation holes
on the aluminum. A refer-
ence indication is also on
the PCB edge.
q
Remove the pcb and use a knife or a screwdriver to scratch the paint from
the aluminum fixation, from the hole closest to the back end. This fixation will
be used later to connect the ground and earth.
q
Mount the three 5mm (0.14”) spacers as shown in the drawing. Use three
hexagonal screws and 3 washer.
Do not tighten the spacers yet
.
q
Position the PCB in the enclosure and check if the position of the spacers is
correct, if so, remove the PCB and tighten the spacers.
Enclosure preparation
FIG. 4
FIG. 5
M3 hex. nut
5mm M3 spacer
Washer
FIG. 6
