19
Final assembly
Prepare the wiring of the mains connector like in the drawing.
First mount the switch into the mains connector assembly.
Do not forget to isolate the soldering connections using a piece of shrink tube.
Use the supplied 0.5mm wire:
Blue for Neutral
Brown for Live
Yellow/green for earth
Use 3 pieces of about 10cm for later connection to the PCB mains connector.
q
Mount the speaker connectors onto the rear panel. (black = negative)
F
Take care of the
isolation washers
, there are two different types! See pic-
ture.
F
Make sure the connectors are very tight fit, and do not make electrical con-
tact with the panel (check using ohm meter!).
27. Speaker and mains connector assembly
Yellow/green
Brown
Blue
Isolation washer !
