9
construction
2. Power cable
+/- 45cm
Cut 45cm of the included cable, measured from the female connector.
Put both cables trough the hole on the rear cover of the housing.
Strip the male and female cable.
Connect the female cable/connector to the output connector
SK2, the male cable/connector to output connector SK1
When both cables have been connected to the K8091EU
mount the strain relief and tighten up with the included 15mm
bolts and M3 nuts.
20mm
7m
m
Twist & thin the wires!
L N N L
AC OUT
M3 bolt
Strain relief
M3 lock washer
M3 nut
SK1 SK2
SK1
SK2