VDPL302FD
V. 01 – 26/04/2013
4
©Velleman nv
Keep this device away from dust and extreme temperatures. Make sure the ventilation
openings are clear at all times. For sufficient air circulation, leave at least 1" (± 2.5 cm) in
front of the openings.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
Mechanical wear and LEDs are not covered by warranty.
A qualified technician should install and service this device.
Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
This device is designed for professional use on stage, in discos, theatres, etc.
The device should only be used indoors.
Use the appropriate power supply (see Technical Specifications below).
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4.
Features
multi-coloured centrepiece that combines two different effects in one fixture
centrally-mounted LEDs shoot flowing beams across the room
quad-sided derby effect constantly rotates multi-coloured beams around the dance floor
independent control of both effects doubles the effect
user-selectable colours in stand-alone mode allow for customized effects without a DMX controller
built-in automated programs
master/slave and sound control modes
DMX controlled via 6 channels
power linking saves time running cables and extension cords
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
display
5
power output
2
control buttons
6
DMX input
3
safety hook
7
fuse holder
4
power input
8
DMX output
6.
Installation
Choose a suitable mounting spot. Mount the device in the desired angle using the included bracket.
Connect the power cord to the mains. Disconnect after use.
