TIMER2 VELLEMAN
1
TIMER2 : CLOCK & COUNTDOWN TIMER
SETTING, STARTING & STOPPING THE TIMER
Use the "HR"- (hours) and "MIN"- (minutes) buttons to enter the chosen period. The max. period is 19h59min.
1. Press the "S/S"-button (start / stop) after the chosen period has been entered.
2. The timer will count down to zero ("0000"), at which point the alarm will be activated for 30 seconds.
3. Press the "S/S"-button to stop the alarm.
REPROGRAMMING OR STOPPING THE TIMER DURING OPERATION
1. The timer can be stopped or reprogrammed at any given time. Stop the timer by pressing the "S/S"-button.
Press again to continue the countdown.
2. Press the "HR"- and "MIN"-buttons simultaneously in order to reset the timer ("0000").
REPEATING THE SAME COUNTDOWN
The same countdown will be repeated if the "S/S"-button is pressed after the alarm has stopped.
SETTING THE CLOCK
1. Press the "SET"-button.
2. Use the "HR"- and "MIN"-buttons to set the clock. Hold these buttons to make the numbers progress faster.
3. Press "SET" again when the clock is set.
Note : the Timer2 displays the exact time in 12h-mode.
INSTALLING THE BATTERY
Unscrew the battery lid at the back of the TIMER2 and insert e.g. an AG13-battery of 1.5V. The positive pole
should be face up.
SPECIFICATIONS
Power Supply : 1 button cell of 1.5V e.g. AG13, LR44
Battery life
: approximately 2 years
Weight :
21g
TIMER2 : KLOK & COUNTDOWN TIMER
TIMER INSTELLEN, STARTEN & STOPPEN
Gebruik de knoppen "HR" (uren) en "MIN" (minuten) om de gewenste periode in te stellen. De max. periode
bedraagt 19u59min.
1. Voer de gewenste periode in en druk dan op de "S/S"-knop (start / stop).
2. De timer telt af naar nul ("0000") waarna het alarm gedurende 30 seconden in werking treedt.
3. Druk op de "S/S"-knop om het alarm te stoppen.
TIMER HERPROGRAMMEREN OF STOPPEN TIJDENS DE WERKING
1. De timer kan altijd worden gestopt of geherprogrammeerd. Druk op de "S/S" knop om de timer te stoppen en
druk nogmaals om de aftelling verder te zetten.
2. Druk "HR" en "MIN" tegelijk in om de timer te resetten ("0000").
HERHALEN VAN COUNTDOWN
Om dezelfde countdown te herhalen moet u de "S/S" knop indrukken nadat het alarm is gedeactiveerd.
