7
Receiver instructions
Receiver instructions
Each transmitter generates a code that must be “known” by a receiver in order to operate. Proceed to the next step to store
one or more transmitters in the receiver memory.
1. Connect the power supply to the receiver unit (see page 9)
2. Hold '
setup
' button
, ‘SELECT’
-led turns on after a few seconds.
3. Press any remote control transmitter button.
4.
‘CONFIRM’
-led lights when the code has been grabbed.
5. Release '
setup
' button.
If neccesary repeat steps 2 to 5 to learn the codes for other transmitters.
31 transmitters can be stored. If memory is full, ’SELECT’ and ’CONFIRM’ will flash simultaneously when 'setup' button is
pressed (see also next page to erase the memory).
The relay outputs can be set in different modes, from a simple on/of contact to a short or long timer.
( Factory defaults: CH1: 1h timer, CH2: 0.5s pulse)
1. Connect the power supply to the receiver unit (see page 9)
2. Push '
setup
'-button repeatedly to select CH1 (left) or CH2 (right) output relay
3. Confirm with a long push (‘
CONFIRM
’ flashes 3 times). The selected relay will remain ON
4. Push ‘setup’-button a number of times, depending on the desired mode (see table).
At each press, ‘
SELECT
’ will flash a number of times, indicating the current mode
5. Confirm with a long push (‘
CONFIRM
’ flashes 3 times). The selected channel will turn off and
the unit is ready for use.
If necessary, repeat steps 2 to 5 for the remaining channel.
The unit returns to normal operation when left idle for 10s.
To learn a remote :
Configuration of channel 1 'CH1' and channel 2 'CH2' :
flashes
Mode
1
2
3
4
5
6
7
8
9
ON/OFF
0.5s pulse
5s timer
30s timer
1min timer
5min timer
15min timer
30min timer
1h timer
Summary of Contents for VM1
Page 42: ...NOTES ...
