Connecting a device to the Relays
Connect your device to the receiver by using the NO (normal open) & COM (common) terminals of each
channel
(10 & 11)
for standard off-mode. If you prefer standard on-mode, please use the NC (normal
closed) & COM (common) terminals
(10 & 11)
.
Please note that the relays are suited for max 48 VDC operation on 5A (resistive load) each.
Both channels are dry contacts (power needs to be supplied by another source).
Generating a new code for the transmitter
Hold CH1 button
(2)
& CH2 button
(3)
on the transmitter simultaneously for at least 5 seconds. The new
code will be generated. After successful completion, the red Indicator LED
(4)
on the transmitter will
flash briefly.
Please note that you will need to re-pair the transmitter with the receiver after generating a new code
for the transmitter.
Clear transmitters from receiver memory (reset)
1.
Power off the receiver by disconnecting the power.
2.
Make sure there are no connections to the receiver on CH1 RELAY
(10)
or CH2 RELAY
(11)
.
3.
Power on the receiver by connecting the power.
4.
Hold the SETUP button
(9)
on the receiver for at least 3 seconds until the CH2 LED
(8)
will turn on.
5.
Again, hold the SETUP button
(9)
on the receiver for 3 seconds until the CH2 LED
(8)
will turn off.
6.
All transmitters are now cleared
from the receiver’s memory.
Please note you will need to re-pair a transmitter to the receiver.
Using the VM130V2set with the transmitter
Press the CH1 button
(2)
on the transmitter for
minimum 2 seconds
to change the state of the CH1 relay
(10)
on the receiver. If the channel was on, it will turn off (and stay off). If it was off, it will turn on (and
stay on).
Press the CH2 button
(3)
on the transmitter for
minimum 2 seconds
to change the state of the CH2 relay
(11)
on the receiver. If the channel was on, it will turn off (and stay off). If it was off, it will turn on (and
stay on).
The red Indicator LED
(4)
on the transmitter will flash while you hold the CH1 button
(2)
or CH2 button
(3)
, indicating transmitting a signal. After 3 seconds, the transmitting will stop automatically to save the
battery.
The receiver shows the status of each channel with the CH1 LED
(7)
and CH2 LED
(8)
.
LED on= channel active. LED off = channel disactivated.
Press the LED button
(1)
to use the flashlight functionality of the transmitter.
Summary of Contents for VM130V2SET
Page 1: ...VM130V2SET...
