![background image](http://html1.mh-extra.com/html/velocitek/sc-1/sc-1_reference-manual_3934704027.webp)
Operating Modes
24
Defining the Wind Direction in VMG Mode
Use the following procedure to program in the direction of the wind so that the SC-1 can calculate your
VMG:
1
Set the upper display to Compass mode and the lower display to VMG mode. Bear-off to a dead
run so you are moving straight downwind.
2
Make sure the
buttons are unlocked
.
3
Put your thumb over the plus button and hold it there. You will see the display scroll upwards
increasing one degree at a time. You can also scroll down by holding the minus button.
4
When the heading on the lower display matches the upper display, release your thumb
5
The SC-1 will beep and switch to showing you your VMG. The device will now use the angle you
dialed in to determine your VMG.
Summary of Contents for SC-1
