![background image](http://html1.mh-extra.com/html/velocitek/sc-1/sc-1_reference-manual_3934704029.webp)
Operating Modes
26
Timer Mode
In timer mode the SC-1 provides a countdown timer that is
user configurable
to specific start sequences.
The start sequence is defined by selecting sync points in
device settings
. For example, a classic dingy
start with a start horn at 5 minutes followed by horns at 4, and 1 minutes is defined by selecting 5, 4, 1
sync points. The timer will start from and reset to the highest sync point. Then the timer will
synchronize to subsequent sync points. The classic dingy start sequence will start from and reset to
5:00 and will synchronize to 4:00 and 1:00.
The timer can be configured to roll over to the timer sequence start value and continue counting. If the
rollover is enabled, for a classic dingy 5, 4, 1 start, the timer counts down in the following manner.
0:03, 0:02, 0:01, 0:00, 4:59, 4:58... If the rollover is disabled the countdown will reset to 5:00 at 0:00.
The following diagram shows the SC-1 with both the upper and lower displays in timer mode indicating
one minute and 36 seconds remaining before the start. Note that there is no mode indicator for timer
mode on the upper display. Timer mode on the upper display is indicated only by the presence of a
colon.
The device beeps multiple times before each minute mark during the countdown. The number of
beeps before each minute mark corresponds to the minute remaining. For example, when there are
three minutes remaining, the SC-1 will beep three times and when there are two minutes remaining the
SC-1 will beep twice.
The unit will beep one long followed by 3 short beeps at 1 minute 30 seconds remaining. 3 short beeps
at 30 seconds and 2 short beeps at 20 seconds.
Beginning when there are 10 seconds remaining in the countdown, the SC-1 will beep once every
second. Beginning when there are five seconds remaining in the countdown, the SC-1 will beep twice
every second. When the timer expires the device will beep continuously for three seconds.
Summary of Contents for SC-1
