www.velocitydetection.com Doc: GLT-301-7-3 Issue: 001 Date: 22/06/2021
VL-MH Non Addressable Mini Horn NAC
The products could be installed in single-gang box.
Before installing and wiring, the power of the loop circuit
must be power off.
After the completion of the terminal to ensure that the
terminal lock, Mini Horn installation diagram shown in
Figure 2.
See Figure 3 for mounting the notification appliance to the
enclosure box.
Note:
Note 1: To remove the cover, Depress the snap at the
bottom of the Mini horn with a key(or flat tip screwdriver)
while pulling the cover up with the other hand.
Note 2: The Mini horn attaches directly to a standard
single-gang box (not supplied) flush mounted or surface
mounted. Attach the mini horn to the electrical box using
two screws (supplied) mounted.
Wire type: 18-12AWG,
Maximum tightening torque: 0.5Nm (4.4Lb.in).
Velocity Detection over Time Zeta Alarms Ltd
declares that this
product is free from defects in material and workmanship and it
will repair or replace any product or part thereof which proves to
be defective in workmanship or material for a period of twelve (12)
months from the date of purchase but not to exceed eighteen (18)
months from the date of manufacture. Please contact
Velocity
Detection over Time Zeta Alarms Ltd
directly for a return
merchandise authorization (RMA) number before returning goods
under warranty. Shipment must be prepaid and
Velocity Detection
over Time Zeta Alarms Ltd
will repair or replace the product if the
failure was caused by a manufacturing defect.
Mounting Appliance Device
Limited Warranty
