www.velocitydetection.com Doc: GLT-322-7-23 Issue: 002 Date: 16/11/2021
ZT-DVS-RM/B
Remote Microphone
ZT-MNS-RM/B to ZT-MNS-100BAS Series, Installation
Connections
(refer to the pictures and orientations shown below)
Note: The ZT-MNS-100BAS panel interfaces directly with the ZT-MNS-RM/B microphone.
Remote Mic:
1) Hold the Remote Mic panel assembly as shown in the illustrations
2) Remove the larger 4-pin header from its connector
3) Choose a color-code scheme for the wires, shown are the 4-conductor FPL colors;
Red (1) +, Yellow (2) A, Green (3) P, Black (4) -
4) Attach the wires to the header and re-insert into the connector
ZT-MNS-100BAS:
1) Locate and remove J3 on the left side of the main Control Module. This will result in a ' RM-FLT '
and 'System' fault until the Remote Mic is connected
2) Remove and store the two (2) Resistors attached to J4 pins 1&2 and 3&4
3) Attach the cabling for the RM, with the pin 1 going to the Remote Mic's pin 1, pin 2 to pin 2, etc
4) Re-attach J3 to the main board, the 'Remote Microphone' Fault (RM-Fault) should go away
Velocity Detection over Time Zeta Alarms Ltd
declares that this product is free from defects in material and workmanship and it will repair or replace any product or part
thereof which proves to be defective in workmanship or material for a period of twelve (12) months from the date of purchase but not to exceed eighteen (18)
months from the date of manufacture.
Please contact
Velocity Detection over Time Zeta Alarms Ltd
directly for a return
merchandise authorization (RMA) number before returning goods under warranty. Shipment must be prepaid and
Velocity Detection
over Time Zeta Alarms Ltd
will repair or
replace the product if the failure was caused by a manufacturing defect.
Limited Warranty
