Velodyne SMSTM -1, User Manual

10

.

w w w . v e l o d y n e . c o m

Digital Drive User’s Manual

4. Connect the audio/video cables between your SMS

-

1 (EQ OUTPUT VIDEO/LEFT/RIGHT 

–

yellow, white, and red respectively) and your electronics (receiver, processor, TV, etc.).  Insert
the color

-

coded cable plugs into the correct EQ OUTPUT receptacle 

–

the yellow plug into the

VIDEO jack, the white plug into the LEFT jack, and the red plug into the RIGHT jack.  The
opposite ends of the cables should be connected to your receiver/processor.  The yellow
VIDEO cable goes to an available composite video input (e.g. aux), and the white/red AUDIO
(L&R) cables go to a corresponding audio input.  As an alternative to composite video, you
may want to use S

-

video (S

-

video connector not included).  Connect the S

-

video from the

SMS

-

1 to an S

-

video compatible input on either your processor or TV.  Consult your

receiver/processor and/or TV owner’s manual for more information.

5. Connect your subwoofer(s) to the SMS

-

1 using the XLR connector or LFE out RCA connector.  

6. Defeat the crossover on your subwoofer(s) (if possible) and set its volume to the

middle setting.  

NOTE: Make sure the audio output goes into your AUDIO system, not your TV!  The SMS

-

1 will

generate test tones used to match the SMS

-

1 to your satellites and to correct for room

anomalies that need to be played by your main audio system.

7. Insert the XLR microphone cable’s 3

-

pin male plug into the MIC INPUT jack (location 7 on

Figure 2) on the front or back panel of the SMS

-

1.

8. Slide the microphone (male connector end first) down through the open, circular sleeve of

the tabletop microphone stand.  Position this assembly at a desired listening position.

NOTE: The Digital Drive Accessory Kit includes a microphone stand adapter (1/2”

-

27 thread)

for use with professional mounting stands.  Be sure to first remove the inner thread piece
(3/8”

-

16) before using.

9. Connect the XLR microphone cable’s female jack end with the male connector end of the

microphone.

10. Sheath the microphone pickup with the foam windscreen cover as a protection against dirt

and airborne contaminants.

A W o r d A b o u t   I n t e r c o n n e c t   C a b l e s

When installing your new Velodyne SMS

-

1 using the line level connections, you should always

use shielded phono cables.  There are many quality cables available today, most any of which
will work perfectly well.  We do recommend that you keep the length of cable as short as
possible to avoid any potential noise problems.

A W o r d   A b o u t   C o n n e c t i n g   m o r e   t h a n   o n e   S M S

-

1

Note that your SMS

-

1 can control up to three subwoofers.  Each of the three subwoofers will

receive the same conditioned signal from the SMS

-

1.  If you wish to run more then three

subwoofers, or wish to individually customize the signal to different subwoofers, you will need
more than one SMS

-

1 connected in a “daisy

-

chain” configuration. This section describes setup

in a daisy

-

chain configuration.