Velodyne SMSTM -1 User Manual Download

Page: 44 / 49

A bout Room Equalization

w w w . v e l o d y n e . c o m

Digital Drive User’s Manual

This section gives some background on room equalization. As a subwoofer plays in a room, the
reflections of the sound waves off the walls create “standing waves,” that is, places in the room
where certain frequencies are louder and others are diminished. In addition to standing waves,
every room will also have locations where cancellations of the sound waves are like black holes
that no amount of attenuation can fill. Thus as a general rule it is better to “cut down” a peak of
response rather than to “boost up” a valley (i.e. possible black hole) of response.

In general, you are looking for a frequency response that is +/

–

3 dB at all frequencies (it is highly

doubtful that your ears can tell a response that is any better than this). The response will always
roll off at the low end (according to the settings of the subsonic filter), and there should be no dip
or peak at the crossover frequency with the satellites. While the goal is perfectly flat response,
this may not be possible in the higher frequencies of the subwoofer’s response due to peaks or
valleys introduced by the satellites.

Do not use any harsh detergents or chemicals to clean the chassis. Abrasives, detergents, or
cleaning solutions may damage the finish on the chassis. We recommend using a damp cloth to
clean the chassis. During normal conditions, your new SMS

1 may be left on continuously without

any problems. If you plan to leave the SMS

1 unused for an extended period of time, we

recommend that you unplug the unit.

If you should experience a problem with the operation of your SMS

1, please check all of the

following before seeking service. Following is a simple troubleshooting guide to assist you.

1. Verify unit is plugged in and power outlet used is active.
2. Is the unit receiving an input signal from your source? A good way to test this is to

connect the EQ audio out to the LFE input on the back panel, then enter setup mode (see
Step 6). The woofer should play the sweep tone used for room EQ.

3. Have all controls on SMS

1 (volume, crossover, phase, etc.) been properly set?

The following conditions require service by a qualified technician:

1. The power supply or cord has become damaged.
2. The unit does not appear to operate normally or exhibits a marked change in

performance.

3. The unit has been exposed to water.
4. Some part of the chassis or circuitry is physically damaged.

Software Updates

At the heart of Digital Drive functionality is the customized software. From time to time, Velodyne
will publish updates to the Digital Drive software. To determine if your unit is a candidate for a
software upgrade, observe the software version number in the upper left corner of the Main
Screen (e.g. V2.1). Then visit www.velodyne.com and observe the version number of the software
available for download. If this version is higher than the version in your unit, you may want to
upgrade the software.

To upgrade the software, you will need an IBM

compatible PC with an available RS

232 9

pin serial

port, and a male

female “Mouse Extension” serial cable. This cable is available from any

computer store, your local Velodyne dealer, or directly from Velodyne. Next, proceed to the
Velodyne web site and click on the link to download the software. Upon download, run the software
and it will instruct you on completing the update process.

Thank you for purchasing a Velodyne!

Care of Your Digital Dr iv e SMS-1

T roubleshooting and Service