VELOMBRA SRL USER MANUAL MAGICAL
Rev. 2 - 06.2012
21 of 70
IT
ALIANO
ENGLISH
FR
ANÇ
AIS
DEUT
SCH
ESP
AÑOL
PRODUCTS
FEATURES
PRODUCT FEATURES
NON COMPLIANCE/ DEFAULT
WARNINGS
GENERAL
Defaults have to be reported within 8 days starting on
installation date on the customer's site (point of reference
is the date indicated on the declaration of correct
installation issued to the end user by the installer). See
general sales terms.
In case wind values should exceed those shown on the statement of correct installation, it is necessary to
close the awning. It is possible to use a properly calibrated anemometer.
Snow support is not guaranteed. The awning must be closed in the event of even moderate snowfall.
To have your product warranty the certificate of proper installation is MANDATORY. A copy must be given to
the final customer and a copy shall be sent to Velombra Srl. The reception of the duly completed certificate
will activate the product warranty.
Any change to the product not expressly authorized by Velombra Srl leads to loss of warranty.
The structures that are located in an urban environment are subject to pollutants (smog, acid rain), smoke
from chimneys, fumes from cooking, and weather in general. It is normal for the fabric and the structure to get
dirty. The structures and the fabric are NOT self-cleaning.
POLES
By applying a lateral load on the pillar an oscillation in the structure may occur. This movement is not a sign
of structural weakness, but is considered normal for the type of structure. The structure has been calculated
by qualified engineers using the Eurocodes and is guaranteed to wind up to the level indicated in the EC
certificate and in the Declaration of correct installation.
CANVAS
Depending on the installation conditions, it is possible that the cloth gets dirty (pollutants, smoke from
chimneys, smog, etc.). In this case it may be necessary to clean the fabric more frequently as indicated in the
section maintenance.
The cloth is not immune from burns caused by cigarette butts, etc..
In particular situations of use of the structure, condensation may occur on the inside of the fabric. To limit this
condition proceed with an adequate ventilation of the room.
The appearance of mold in the embossing of the fabric is due to the presence of moisture on the sheet that
favores the formation of micro-organisms. It is therefore necessary to clean the fabric at regular intervals, more
frequently if necessary.
LAMPS
To maintain good efficiency in the seals, thereby ensuring the IP product protection level (shown in the
manual), you must do the maintenance indicated in the manual.
AWNING
SAILS
Creasing on the roll-up sails cannot be considered a cause for complaint.
The presence of folds on the sail immediately after the first installation may be due to packaging. The folds will
disappear completely after about 6 months of installation.
