14
¢
HOW TO USE THE BICYCLE COMPUTER
Per the above requirements to install all the parts,
and set the below data, then you can use the
bicycle computer.
1.Reset previous value to zero before each
FIG.O
SET+MODE
2S
MODE for changing
from low to high
MODE for changing
from hour to minute
KM/H
MODE
MODE
MODE
MODE
KM/H
2074
KM/H
SPD
KM/H
KM/H
Set speed unit
Set circumference
12Hr/24Hr
Set clock
4.Do the same as above, press SET to select
value and press MODE to confirm and proceed
to next. (FIG.O)
Note:
●
The bike circumference unit is mm.
●
When in 12H format, PM is for afternoon. If
no PM, it is for morning time.
measurement. When the speed is zero(except
SCAN mode), hold SET for 2 seconds to reset the
value of DST(distance), RTM(riding time),
AVS(average speed), RES(relative speed),
MXS(max. speed), and enter SCAN mode.
2.The measurement begins once riding on the
bicycle. If the computer receive no signal during
riding, the "
"
in the display will not flash. Stop
riding and check if the magnet place well, if the
sensor got enough power.
3.Press MODE to select the display mode or SCAN
mode. Each display will be changed in order each
4 seconds when in SCAN mode.
4.The computer will turn off automatically if there is
no operation or signal over 8 minutes, and all the
memory will be kept. You can press any button to
turn on the computer to receive the signal again.
HOW TO WEAR THE CHEST BELT
(FOR MODEL JS-204A/JS-212A)
In order to get correct heart rate signal, you need to
properly wear the chest belt (FIG.O). The chest belt
will transfer the data to the bicycle computer .
1.Wet the conductive pads on the underside of the
transmitter with water, sweat or a conductive gel to
¢
15
Copyright © 2010 www.Veloset.co.uk UKET limited
