FIG.Q
17
computer) will start transmitting and receiving
signal once batteries are in place. Both units
should be worn or mounted within an effective
distance of 80 centimeters (31inches). If the
signal have become unsteady,
A. Shorten the distance between the transmitter
and receiver.
B. Re-adjust the position of the transmitter.
C. Check the batteries. Replace them when necessary.
HEART RATE MEASUREMENT (FOR
MODEL JS-204A/JS-212A)
Press MODE to pulse display, if
“
”
flash in
right corner of the LCD.
The computer is well
r e c e i v i n g t h e p u l s e
signal and will show your
heart rate value in a
short time, see FIG.Q.
Note:
●
●
¢
If you wear the
heart pacemaker or any other medical
equipment, please do not measure
heart rate.
Please do not measure heart rate near
FIG.P
ensure a solid contact.
2.Strap the belt across the chest. Adjust the strap until
the conductive pads sits snugly below the pectoral
muscles for an accurate heart rate signal.
Hints:
●
The position of the transmitter affects
i t s p e r f o r m a n c e . M o v e t h e
transmitter along the strap for the
best transmission. Avoid areas with
dense chest hair.
●
In dry, cold climates, it takes the
t r a n s m i t t e r a w h i l e t o f u n c t i o n
s t e a d i l y. T h i s i s n o r m a l a s t h e
conductive pads need a film of sweat
to improve contact with the skin.
EFFECTIVE RANGE
The transmitter in the strap and receiver(bicycle
16
Copyright © 2010 www.Veloset.co.uk UKET limited
