- 34 -
User Manual
Athena
English
TIMER PROGRAMMING
• • In this menu it is possible to determine system switch off/switch on parameters
(countdown), and view the system's work hour-count for the current zone
.
• When system switch-on is scheduled, all the zones will be put "off" until the
scheduled date; after that date every zone will take on the operation mode it was in
before the switch-off. When in this operation mode the display shows symbols
and
.
• When system switch-off is scheduled, all the zones will be put "off" on the scheduled
date. When in this operation mode the display reads symbol
.
NOTE: to exit the switch-on or switch-off countdown before the time expires,
just set the countdown time to zero.
• The system will be switched on or off when the timer reads 00:00. The
countdown
program affects all control zones simultaneously.
• To set the countdown program, press the
[OK]
when in the timer programming menu.
• Press keys
and to select switch-on or switch-off.
• To set the date, use arrow keys and to move inside the data field and change
the values using arrow keys and . If the date field reads [--.--.----] the switch-
on/switch-off date is not set. When the date is set, press the
[OK]
key to confirm.
Press
to return to the main page.
NOTE: the countdown program cannot be enabled if the extension program is
already enabled.
• To view the system's work hour-count, press key or when in the timer
programming menu. The work hours refer to the temperature zone shown before
entering the menu.
NOTE: to set the hour count for the current zone to zero, hold the [OK] key down
for approximately 3 when in the hour-meter reading menu. The maximum hour-
meter value is 65535 hours.
ESC
ESC
ESC
