- 42 -
Iride Chronothermostat User Manual
BATTERY REPLACEMENT
The model Iride (batteries) signals the status of depleted batteries switching on the
symbol
(field
(10)
) and making the display to flash.
In this status the regulation is always guaranteed, but it’s advisable to replace the
batteries as soon as possible! (*)
If the charge level of batteries further decreases, the chronothermostat enters into less
consumption mode, it switches off the display and it doesn’t perform any regulation.
(*) Remove the depleted batteries and replace them with the new ones in a maximum
time of one minute (charge reserve) to avoid to lose the settings of date and time
(the performed programmings on the contrary remain memorized even if this limit is
surpassed).
Attention: after batteries replacement, the display will switch on within 15
seconds at max.
Dispose of the used batteries observing the
laws in force in relation to the disposal
of hazardous waste
.
The removal of the device occurs
by pulling on the convexity of the frame
(see figure).
DEVICE RESET
If you want to erase all performed settings and to recharge the default values, proceed
as follows:
1. to switch off and to switch on the power of the chronothermostat (230 V versions)
or to extract the chronothermostat from the wall-mounted base and reinsert it
(battery versions)
2. during the flashing of the keys press the key
until the display shows the writing
dEF
.
Default values are indicated on page 42 of this manual.
English
Summary of Contents for Iride
