E
n
g
li
s
h
- 8 -
User manual memo DW E
and press
“Ok”
to
confirm and go on to the next parameter.
The sequence of parameters
to be inserted is hours
´
minutes
Press
“Ok”
to confirm.
The instrument then goes into
normal
operational status
and is ready to work.
The display shows the values for the date,
time, status relay, day of the week (on
the first line in letters and lower down in
numbers) and the DST/CET symbol.
Note: if the instrument is not fed by
the mains, on the first line of the
display instead of the day are the words
.
In this condition backlighting is not active
and the relay not switched.
C1
C2
R
Ok
ON/OFF Events
ON and OFF events consist of switching the relay to the on or off
position.
They may be daily (every day at the same time) or weekly (one or more
days during the week, each week).
IMPULSE events
An impulse event can be an on or off type and may last for a maximum
of 59 second
:
ON
OFF
At the end of the on impulse the relay will always be in the off status; at
the end of an off impulse the relay will always be in the on status.
An impulsive event can be interrupted following a manual operation.
CYCLE events
A cycle event is a programme which repeats itself over a preset period
of time (maximum duration 1 week) during which there is a succession
of on and off switching.
The cycle programme always starts from the on status and always ends
in the off status. The duration of the on and off status cannot be less
PROGRAMMINGS
