8
7
IGNITION
To perform the correct ignition of the burners, follow the steps below:
1 - Soak the lighter (wick) that accompanies the product in alcohol and light it;
2 - Rotate the manipulator corresponding to the burner you want to turn 90 ° counterclockwise;
3 - Insert the igniter (wick) into the hole corresponding to the ignition located on the panel, until you
pass the hole in the burner plate;
4 - Make sure that the burner is lit. If the burner does not light up, repeat the procedure;
5 - Remove the igniter (wick) and do the same with the other burners (the order of ignition does not
interfere with the use of the equipment);
6 - After lighting all the burners, the manipulator corresponding to the PILOT can be turned
counterclockwise by 90 ° so that all the pilot burners are lit and you can now turn off the main burners
and re-ignite them only by turning the corresponding buttons;
OPERATION: The flames of the burners will heat the baffles (plates), which will radiate the heat with
uniformity for the food placed on the grates.
5. OPERATION
GRIDDLE
GRIDDLE
For installation under ventilation hood only.
LEG ASSEMBLE
1 - Adjust the leg set on the equipment body.
2 - Fix the nut (1/2") and washer (1/2")
PROPANE GAS CONVERSION INSTRUCTIONS
A griddle is equipped with xed ori ce hoods and shipped from the factory for use on natural gas.
To convert to propane gas, install the propane burner ori ce hoods supplied as follows:
1 - Remove the griddle plate by lifting with two people and set a side.
2 - Slide the burners back o of the valve ori ce hoods a couple of inches and let it rest.
3 - Remove the natural gas ori ce hoods with a 1/2 wrench.
4 - Apply a very little bit of pipe dope on the threads of the valve.
DO NOT APPLY PIPE DOPE INTO ORIFICE HOOD.
5 - Attach the supplied propane burner ori ce hoods with a 1/2 wrench.
6 - Convert the pressure regulator from Natural to Propane gas by inverting the snap-in device beneath the
cap on the regulator. This will require a fair amount of pressure. Do not remove the spring. When replacing
the cap make sure the snap-in insert goes down on top of the middle of the spring.
7 - Test for proper pressure; 10 W.C. (water column) using a manometer.
8 - Slide burners back onto the ori ce hoods.
9 - Apply the Propane Notice stickert to the front of the unit for futer reference.
1
2
3
4
180º
PROPANE GAS
NATURAL GAS
KNOB ASSEMBLE
Plug the knob at the gas valve.
1 - KNOB
2 - GAS VALVE
