VendNet 3120-GF12 II, Service Manual

9

Motor Count Mode

The Motor Count Mode displays the total
number of functional motors configured within
the machine. This number should equal the total
number of selections. Only the total number of
functional motors displays; individual selection
numbers do not display.
Press the Service Mode Button, then press 

[   2   ]

.

The controller tests each motor in the
configuration.
If the motor count displayed does not agree with
the total number of selections in the machine, the
electrical circuit of all motors is not complete.
To exit, press the Service Mode Button once.
To determine which motor is not functioning:
Were faulty motors displayed when placed in the

Service Mode

?

Test vend single selections.
Test vend all selections.
Refer to the “Troubleshooting” section of this
manual for further assistance.

Accountability Mode

The total vends and total cash are displayed. This
information is not resettable. The display will
continue to flash the accounting data until the
mode is exited.
Press the Service Mode Button, then press 

[   3   ]

.

Acct

 displays.

For the Vend Count, press 

[   A   ]

. The first four

digits of an eight digit number display. Then, the
last four digits will display.
For the Cash Total, press 

[   B   ]

. The first four

digits of an eight digit number display. Then, the
last four digits (including any decimal point)
display.
To exit, press another function key or press the
Service Mode Button.

Price Setting Mode

A vend price must be set for each selection. The
price programmed must match the desired item
and price scroll. To check a price, push the
selection numbers while in the 

Sales Mode

.

Press the Service Mode Button, then press 

[   4   ]

.

Prc

 displays.

NOTE

The coin mechanism must be installed to
verify the correct price.

If the item price is set to .00, the item will vend
for free.
Press the selection letter and number of the
selection you want to price. That selection’s
current price displays.
To change the price:

press 

[  #  ] 

t

o decrease the value, or.

press 

[  *  ] 

to increase the value.

To save the price displayed:

press the selection number of the
next item to be priced,
press another function key, or
press the Service Mode Button.

NOTE

When setting vend prices, make sure the
price scrolls on the product shelves agree
with the vend prices programmed into the
controller and that the selection labels are
properly located below the item.