* The blind must be installed on the brackets when
adjusting.
Installation
continued…
Please write a review on our
website at…
www.venetablinds.com.au
Feedback?
We would love to know how you
went with your installation…
How to install your
#65101-40160-D
Cordless
(Roller Blinds with Raceway)
Difficulty:
3
How to install, operate and maintain your
#65101-40160-D
Cordless
(Roller Blinds with Raceway)
Difficulty:
4
5
Cordless Operation
Use the “hook” portion to hook
the handle to lower the blinds.
Place the U- shape channel of
pole under the handle and push
up to lift the blinds.
Great Job… Enjoy your new Veneta Blinds!
1
Dusting
Dust can be removed using a feather duster or vacuum with brush attachment on low suction.
2
Spot Cleaning
Use a warm damp cloth or a mild detergent for tougher stains.
Dab the affected area, but do not rub the fabric. Finish with just a warm damp cloth.
Allow the fabric to dry in the lowered position.
Maintaining your
Blind
Installation
continued…
Pull the handle downwards or upwards
and the blind will be lowered or raised.
The tension in our cordless roller blind can be adjusted to
provide optimal light control and to ensure easy and
dependable operation on a variety of window types and
sizes. If a cordless blind begins to slide down on its own or it
fails to roll up, the issue can be easily fixed by turning the
adjustment dial towards “+” to increase the tension.
Conversely, if the cordless blind cannot stop at the desired
height and tends to roll up by itself, the tension can be
decreased by turning the adjustment dial towards the “-”.
Need HELP?
Call our
Customer Service team
for assistance
1300 836 382
4
Hold Down Brackets Installation (optional)
Use 19mm round head screw to secure each bracket.
Snap the front rib of the raceway into the bracket, and then turn the raceway backwards
and upwards so that the back of the raceway is stuck to the back plastic part of the
bracket.
Attach Handle to Hem Bar…
Step 1:
Turn over hem bar and you can see a label attached at the center of the hem bar.
Step 2:
Align the center of the bottom of the handle with the label.
Step 3:
Hook the handle to the hem bar from top to bottom.
Step 4:
Press the handle from top to bottom to make the top of the handle clip into the hem bar.
Step 5:
Tear off the label from hem bar.
Handle installation and Removal
①
③
Label
The center of handle should
be aligned with the label.
④
⑤
Remove handle from hem bar…
Use straight screwdriver to pry the bottom of handle
from hem bar and then the handle can be removed.
③
③
②
②
①
①
Use a tool to push back the front or back plastic part of the brackets.
Turn the back side of the raceway downward so that it detaches from the bracket.
Finally remove the raceway by pulling downward from the brackets.
or
Removal of the Blind….
②
3
B.
