VG HST 3001
6
OPERATION
Only use the appliance to straighten dry hair; never use it on wet hair, synthetic hair or
wigs.
•
Plug in the appliance and switch it on by pressing the on/off switch during
approximately 4 seconds.
•
The LCD screen turns on and 180°C flashes.
•
To adjust the temperature, press briefly on the buttons
+
to increase the temperature
and on
-
to decrease the temperature.
Notes :
−
the ceramic plates reach a high temperature during use. Do not touch these plates
and avoid contact with the skin.
−
If you have thin or fragile hair, choosing too high a temperature could damage or
even burn your hair.
•
For an optimal result, use the hair straightener on clean, dry and tangle-free hair.
•
Position the hair straightener as closely as possible to the roots and take a section 2
to 3 cm wide.
•
Slowly glide the hair straightener from the roots to the ends. When you get to the
ends, turn the hair straightener in a half-circle inward (or outward).
•
Hold the hair straightener for 2 to 3 seconds and release.
•
Repeat this process several times if necessary in order to obtain an optimal result.
•
To give more volume to your hair, use an upward motion to lift the roots from the
scalp when the appliance is close to the roots, i.e. at the beginning of the
straightening process.
•
When you are finished, press the on/off switch. The pilot light goes off.
•
Unplug the appliance after use and let it cool down.
CLEANING AND CARE
•
Unplug the appliance and wait until it has fully cooled down before cleaning or
storing it.
•
To clean the ceramic plates and the body of the unit, use a soft dry cloth.
•
Never use detergents or abrasive products.
•
Never wrap the cord lightly around the appliance.
•
Never hang the unit by the cord but use the dedicated hanging loop..
•
Never immerse the appliance in water or any other liquid.
Summary of Contents for VG HST 3001
Page 2: ...VG HST 3001 2...
