ENG-8
If a fault occurs, first check the points listed below before taking the set in for repair.
If you are unable to resolve a problem by following these hints, consult your dealer or service center.
Note: Do not open the unit as this could result in an electric shock. Under no circumstance should you try to repair the set yourself.
Please consult a qualified technician or your nearest service centre.
No power
Ensure that the power cord is connected securely.
Ensure that there is power at the main power supply.
Ensure that the batteries are inserted correctly.
No sound or poor sound
Adjust the volume.
No response from the unit
Disconnect and re-connect the AC power cord, then turn on the unit again.
Electrostatic discharge, re-connect the AC power cord after a few seconds.
No disc detected
Insert a disc.
Check if the disc is inserted upside down.
Wait until the moisture condensation on the lens has cleared.
Replace or clean the disc.
Use a finalized CD or correct format disc.
The CD skips tracks
Ensure that the CD is not damaged or dirty.
Ensure that the programme mode is not activated.
USB device not supported
If the USB device is incompatible with the product. Try another one.
Poor radio reception
Increase the distance between the unit and your TV or any home appliance.
Fully extend the telescopic antenna
Environmental information
The packaging can be easily separated into three material types: Cardboard, polystyrene and plastic.
This packaging consists of material that can be recycled, if dismantled by a specialized company. Please observe the local regulations
regarding the disposal of packaging, dead batteries and old equipment.
Troubleshooting
