INST
ALLA
TION MANUAL
INST
ALLA
TION
22
Light Bulbs
(BCS3, BCSM and NCS3 Series only)
1 ]
Align the bulb leads with the small indentations located on the border of the lamp location on
hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in
the socket.
2 ]
Gently push upwards and turn clockwise until secure.
The BCS3, BCSM and NCS3 Series range hoods require two shielded Halogen Bulbs (120 V,
50 W max., MR16 or PAR16 with GU10 base) (included only with BCSM Series range hoods).
NOTE: The Suction Cup Tool (included with hood) can be used to install and remove light bulbs.
Press suction cup tool on bulb and rotate counterclockwise to remove bulb or clockwise to
install
bulb.
SUCTION
CUP TOOL
!
WARNING
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent
the risk of personal injury, only install shielded halogen lamps. Also, never install a cool
beam, a dichroic lamp, a lamp not suitable for use in recessed luminaires or identified for
use in enclosed fixtures.
Install the Filters
Ducted Installation Only:
Re-install grease filters removed in step
2
on page 11, under “Prepare the Hood”.
Non-ducted Installation Only:
Purchase two non-ducted filters from your local distributor or retailer (see product specification label
for filter type). Attach the non-ducted filters following instructions packed with the non-ducted filters.
!
CAUTION
Most GU10 LED replacement bulbs commonly found in the market are not designed
for use in a cooking environment and might not perform as advertised. Their usage
with this product is not recommended.
BULB LEADS
BULB LEAD
GROOVES
(IN SOCKET)
