PROGRAMMING NOTES
You will be prompted to enter both heat and cool
setpoints even if the thermostat is configured for
heat only, or cool only.
Heat & Cool setpoints for Occupied 1 are the same for
each day. Heat & Cool setpoints for Occupied 2 & 3 can
be adjusted differently for each day, if desired.
If the start time is set for later than the stop time,
the
program will run from the start time to midnight and from
midnight to the stop time on the same day.
For example:
9:00pm start, 8:00am stop, on Monday. This program
will run from 12:00am Monday to 8:00am and
again from 9:00pm to 11:59pm on Monday.
The Unoccupied settings take effect at all times when:
(
1
) the program is on
and
(
2
) the current time is outside
an occupied period. For this reason start and stop
times are not necessary for unoccupied.
If the
same
start and stop times are programmed in for
an occupied period, then it will run 24 hours.
If one occupied period starts and stops within another
occupied period, the lower occupied # has priority.
example: If Occupied 3 is programmed to be “on” 24
hours, and Occupied 2 is programmed to run that day,
then Occupied 2 settings will take precedence during
that time.
For
If only 1 Occupied period is selected, the Occupied 2 & 3
steps will be skipped. Further, if only 2 occupieds are
selected, the Occupied 3 steps will be skipped.
Programming
Occupied & Unoccupied Periods
During the Override mode (
see page 12
), the Occupied 1
Heat & Cool setpoints are used.
Page 17
