22
User Setup -
Wireless Modules
Please follow the instructions included with the Z-Wave module to join the
Network or view status. The general instructions are below.
Z-Wave Module
Press the Accessory Status button to view the status of the thermostat’s
connection to the Network.
Press the Accessory Setup button to enter the Z-Wave Network setup:
Press the Cooler button to join the Z-Wave Network and start the connection
process on the Z-Wave controller.
Press the Warmer button to remove this thermostat from the Z-Wave
network. When prompted, press the Mode button to remove the thermostat
from a connected controller. If the controller is not present, press the Fan
button to remove the thermostat forcefully from the network.
Please use this procedure only in the event that the network primary
controller is missing or otherwise inoperable.
Notes regarding Voyager’s Z-Wave plus module:
• The Voyager Z-Wave thermostat supports association group 1.
• This group supports up to 5 devices and is used for reporting setpoint
changes performed by the user on the thermostat, and for reporting when
the thermostat was reset locally by the user.
• The Z-Wave command set allows for the implementation of the thermostat’s
Home/Away and Vacation settings as described on page 19.
• Products from different manufactures and product categories can be part
of the same network and non-battery powered nodes may act as repeaters,
regardless of manufacturers.
Z-Wave Module
Z-Wave Module
ACCESSORY
STATUS
ACCESSORY
SETUP
