26
User Setup -
Time Period Programming
To enter Time Period Programming
screens, Press and hold PROGRAM
until the scrolling prompt appears.
OFF - Time Period Program is off.
RUN - Time Period Program is running.
HOLD TO SET - Press and hold
PROGRAM to make Time Period
Programming changes.
Select Day of Week to program -
Press the WARMER or COOLER buttons
to choose the day of the week to be
Press MODE to advance to the next step.
OFF
RUN
HOLD TO SET
OFF
|
RUN
HOLD TO SET
Programming a Daily Schedule
Selecting Your Time Period Schedule
(setup step 1)
This thermostat may be configured to be programmable or non
programmable.
7 Day Program - Allows all seven days to be programmed independently.
Non Program - No advanced time period programming available.
1 Day Program - Allows one 24 hour day to be programmed. This same
schedule will be repeated every day the program is set to run.
5/2 Day Program - Allows weekdays, Saturday, and Sunday to be programmed
independently.
Selecting Your Available Modes
(setup step 2)
Auto-Changeover - Allows the thermostat to turn on heating or cooling based
on room temperature demand. Also allows the manual selection of HEAT only
or COOL only and OFF.
Heat and Cool - Allows the thermostat to turn on heating or cooling depending
on which one has been manually selected. Auto-Changeover is not available
when this is selected.
Heat Only - Allows the thermostat to only turn on HEAT or OFF modes.
Cool Only - Allows the thermostat to only turn on COOL or OFF modes.
(continued next page)
WARMER
COOLER
MODE
ADJUST
NEXT
