15
VenNet Sensors
Pairing a Sensor
1.
Press and hold the PAIR button on the sensor for 1 second.
a. Upon release of the PAIR button, the LED
will flash twice.
b. The sensor will remain in its pairing state
for 1 minute.
2.
Move the sensor to within 3 inches of the thermostat.
3.
The thermostat will recognize the sensor and display
NEW SENSOR IS DETECTED.
Press WARMER to pair the sensor to the thermostat.
a. The thermostat will display PAIRING.
b. Pressing COOLER will remove the
message from the display and stop the
pairing procedure on the thermostat.
4.
Once pairing is completed, you must select
the type of sensor, Remote or Outdoor.
a. At this point, the thermostat will display REMOTE SENSOR TYPE,
press WARMER or COOLER to change, press MODE to accept.
I. Pressing WARMER or COOLER will allow you to choose REMOTE
SENSOR or OUTDOOR SENSOR.
II. Press FAN to accept the type of sensor chosen.
III. The thermostat will display SENSOR # IS PAIRED twice and return to
the Home Screen.
5.
If set as REMOTE and you wish to use the sensor for temperature control,
alter setup steps 43 and 44 as necessary.
6.
You may use Skyport to assign a logical name to the sensor.
NEW SENSOR
