25
Wired Sensor Type*
(Setup Step 42)
Specifies the use of the connected, wired sensor. The choices are: Remote, Supply,
Outdoor. Only the remote option allows control of the sensor.
Control to Temp Source*
(Setup Step 43)
This feature allows the user to specify which temperature sensor source the thermostat
will use to measure room temperature.
Thermostat
: uses the internal thermostat sensor only.
Wired Remote:
uses the attached wired remote sensors.*
Wireless Remote:
uses WiFi or VenNet sensor specified in step #44.
Average of Wireless Remotes:
combines and averages all paired WiFi or VenNet
sensors.
Average of Thermostat and Wired Remote:
averages internal and attached wired
remote sensor*.
Average all Sensors:
averages internal, any attached wired or paired wireless sensors.
* These options only appear if step #42 (Wired Sensor Type) set to “remote”
NOTE: If a remote sensor is being used, the degree icon on the large room
temperature display will blink.
Wireless Remote to Use*
(Setup Step 44)
Specifies which paired WiFi or VenNet sensor to use for temperature control. This step
only appears if step #43 (Control to Temp Source) set to “Wireless Remote”.
Setup Steps
Press the SETUP button, then press MODE repeatedly until the
desired setup step appears. Use the WARMER or COOLER buttons
to make selection. Press MODE to advance to the next step.
Press/hold MODE to go backwards to prior steps. Press SETUP to
leave the setup screens.
WARMER
COOLER
MODE
SETUP
